Cause |
Troubleshooting |
The main switch is not switched on |
Switch main switch to position "I" |
Mains failure or Failureof a phase |
Wait for power to return or Remedy cause of power failure (e.g. defective operational side fuses) |
Overload protection has triggered |
Pull sliding table back in front of saw blade |
Sliding table moved beyond middle of saw blade |
Release the EMERGENCY STOP button again by pulling it |
EMERGENCY STOPbutton pressed |
Close door or lower protective cover Switch off the main switch, open switching cabinet and determine which of fuses F1, F2, F8 is defective. |
Door on machine standor lower protectivecover in front of thesaw blades opened |
Clarify and remedy cause |
Control circuit fuses defective |
Replace defective fuses, use fuses of the same ratings as replacements! |