[1]  Guide the pins of the table length extension into the holes on the face of the table plate.
[2]  Secure loosely to the table plate with two M10 nuts and shake proof washers(1).
[3]  If necessary, correct the alignment and flushness by readjusting the support screws (2).
[4]  Tighten the M10 nuts. 

 
[1]  Guide the pins of the table length extension into the holes on the face of the table plate.
[2]  Secure loosely to the table plate with two M10 nuts and shake proof washers (1).
[3]  If necessary, correct the alignment and flushness by readjusting the support screws (2).
[4]  If necessary, correct the height by means of eccentric screw (3).
[5]  Tighten the M10 nuts.


[1] Fit the measuring bar easily with M6x30 countersunk screws (1).
[2] Knock a 6x45 clamping pin (2) through.
[3] Tighten the countersunk screws(1).


[1] Put the fence bar bolts (1) through the holes in the main table.
[2] Attach the M20 nuts from the rear of the main table and tighten them.
[3] Carefully push the rip fence (2) from the right to left side on to the fence bar .