Checking Free cut sliding table
Set saw blade to max. cutting height, cut a short piece of a test piece (where possible MDF) at the mitre fence. The difference in the noise between the cutting and non-cutting teeth allows you to determine whether the sliding table is
set correctly. On the passage of the rising teeth a slight fluttering noise should be heard compared to the noise of the cutting teeth.
Adjustment
Release the sliding table attachment at both ends and in the middle (where present). Release the lock nuts on the fence screws. Make the appropriate adjustments and re tighten the lock nuts. Then readjust the sliding table and tighten all securing screws again.
Checking free cut rip fence
Set the saw blade to its max. cutting height, cut a. 300x450xmm test piece (where possible MDF) at the rip fence. The noise of the rising teeth must be the same as for the free cut on the left with correct adjustment of the sliding table.
Adjustment
Release the bolts connecting the table extension to the circular rod. Then, by adjusting the center locknuts, change the position of the circular bar and thereby of the rip fence.

Adjustment motorised rip fence (Type X)

• After removing the cover cap release the clamping screws (1).
• Set the free cut by adjusting the setscrews (2).
• Tighten the clamping screws (1).

CAUTION!
When a scorer is used ensure that both free cuts are set to approximately the same!